Air-cooled UV vacuum pumps for IS machines in Malaysia

Two pumps model UV8 and two model UV16 with all dedicated accessories operate continuously since then, at full customer satisfaction. The target of high-speed container glass manufacturing with a lowest rejection rate was achieved. Same year followed the installation of a second UV pumps system for the Malaya Vietnam Glass Plant, which was commissioned in October 2004.

There was no Service Center in the area at the time, thus Pneumofore technicians carefully instructed how to operate and maintain the pumps. Considering 5 to 10 % increased productivity, thanks to use of vacuum in the moulding process, all required attention was dedicated from the customer to keep the vacuum system performance.

In 2005 the third and largest vacuum system was ordered with one UV30 and one UV16 vacuum pump for Kuala Lumpur Glass. The commissioning was executed in January 2006 by a Pneumofore engineer with the support of the distributor and Service Center IMVT from Bangkok, Thailand. Below two pictures of this last installation, which reconfirmed the reciprocal trust and respect of the involved companies.